Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Grease Monkey Tuners

Joined on the:

Oct. 13, 2013

Score

1230

Comment(s)

25

Voted question(s)

1

Voted answer(s)

7

Votes up

0

Votes down

8

Votes up received

8

Votes down received

0

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

1

How close do you have a solution for the 2023 Ford F450 Super Duty?

This vehicle is completely different.. having 3 Canbus line running FD protocol. I have 4 units that are itching to get remote starter done

0

Ford Remote Starter Conditions

2021 Ford F450 Does your remote starter solution only enables the OEM remote starter on this vehicle? Would the EVO-ALL or EVO-ONE will still remote start this truck even if: - CHECK ENGINE LIGHT IS ON. - LOW FUEL LIGHT IS ON. - VEHICLE BATTERY VOLTAGE IS TOO LOW We are planning to install these on 4 work trucks

0

EVO-ALL THAR-VW3 TB-VW Issues

2012 VW Jetta (Gas) Key Start EVO-ALL THAR-VW3 TB-VW Everything was soldered! Programmed good but it didn't remote start at the first time but the it auto tried the 2nd time, started fine this time and a few times after.. client took the car home.. all good.. 1 week later, got a call from the client saying that the remote starter is not working and also wont start normally wiith the key. The only way they got it started was they unhooked the battery and replug it again. The next day, got another call and client said that the vehicle stopped while driving.. they pulled over and waiting a few minutes and the vehicle started again but engine light came on. Took it to a shop and scanned codes: Code: B104C29 Description: Key - Implausible Signal State: Passive/abiogenesis Code: 00474 Description: Anti-Theft Immobilizer System Control Module State: No Signal/Communication I got the vehicle back into the shop.. replaced the EVO-ALL.. double checked all my connections and even used the opposite side of the transponder wire pair.. soldered it and made sure that the TB-VW wire config is going the right way.. programmed fine but now the vehicle remote starts fine on first try! Guess what.. client called back again after a few days with the same no remote and key start issue.. battery unplug and replug make it work again, Got the vehicle again and now ths time.. i actually replaced the THAR-VW3 and the TB-VW. Its been 2 weeks now and client hasn't called back yet.. Now... i have to figure out if the T-Harness will cause no start, stall and engine light codes

0

2004 Chrysler Crossfire aka Mercedes SLK

I know that his vehicle needs a key wrap! But.. just wondering if there is any chance that the Evo-ALL could support the CAN data on this vehicle for the convenience features only. The Chrysler Crossfire is basically the rebadge version of the Mercedes SLK

0

2019 Mercedes Benz Sprinter

I have heard rumors that with this vehicle the EVO interface could control the marker lighs to flash through CAN/Data? Could anyone confirm this?

0

2007 Ford Escape (Standard Key) Features SupportedÉ

Could someone confirm if the EVO-ALL supports the convenience features for this vehicle through CAN-BUS Thanks,

0

2009 - 2014 Audi S4 Parking/Marker Light

Hey Fellas, I installed an EVO-ALL w/ AUD1 T-Harness on a 2011 Audi S4 as standalone using Guide # 77161. Remote starter works great but park lights don't turn on when its running. I had the parking light control ON the settings/options using through the flash-link updater and I don't see an analog wire to actually connect the EVO-ALL/EVO-ONE into vehicle's parking light circuit. Am i missing anything? Thanks!

0

ProStart CT-3310 - Does it do 2 Way Data-link?

Do you guys know off hand of the Canadian tire "special" ProStart CT-3310 can do 2 way data-link? There is a 4 pin bypass port on it but not sure on if it supports 2 way or only 1 way. If it does support it... is it a D2D protocol? Will be using an EVO-ALL

1

Is there any updates on the EVO-ALL as an Alarm?

Any new updates and revisions on Guide # 12971? Also, I have source out all of the other accesories except a shock sensor? any recommendations that you guys have tested and works?

1

2016 Venza PTS - EVO-ALL Standalone - Compatible and Verified!!!

This is just to let everyone know that the EVO-ALL works as standalone remote starter on the 2016 Toyota Venza! Wire colors and pin postions are the same as on the installation guide # 8611 REV.: 20141202 for the 2009 - 2014 models.

1

EVO ONE Park Lights Flash Everytime Brake Pedal is Depressed While Engine is Running and E Brake is Disengaged

EVO-ONE w/ CHR5 THAR on a 2014 Jeep Wrangler Standard Transmission. Remote starter and ready mode functions all work great, however the EVO-ONE "clicks" 3 times and park lights flash right after the brake pedal is depressed while the engine is running and the parking brake is off/disengaged. (This does not occur when the parking brake is up or engaged). What what should we do to so that this doesn't happen. The customer is annoyed that it does this while driving.

0

2013 Dodge Grand Caravan - Factory Horn Trigger

Is the factory horn trigger from the horn switch data on this vehicle now? Wirecolor.com only shows positive (+) to trigger the factory horn right off the horn(s) or TIPM. Could you please verify that there is really no negative (-) horn trigger from the steering column on this vehicle at all? My next question then is... could the EVO-ALL (Alarm Enabled) horn output (green wire) be set to constant instead of pulse to be able to hook up an aftermarket siren? I Didn't see any options on the flashlink program.

1

EVO-ONE (Remote Starter/Alarm) Options Description Write Up

We are very excited to try out your new EVO-ONE as both and an alarm and remote starter on some of the vehicles that we will be working on. However, we just need more info and descriptions on each options/settings on it and what the possible connections (detailed wiring digrams for advanced options) to it? We tried flashing one connecting one on the flash link updater (toggled as a remote starter) and opened up the options and lot of it, we are not sure of what it does and how it works exactly. Do you have some sort of a full detailed guide or a write up? We strive to know how the product works before we install them into a customer's vehicle. We have been installing Compustar products for a long while now and we pretty know its capabilities and options. It'll be nice if we can learn the EVO-ONE as well. Thanks!!!

0

Doors won't unlock unless the disarm/unlock button on the remote starter is pressed the 2nd time

2011 Nissan Juke (Reg Key) Compustar CS800-S Remote Starter 2 Way Datalink (APO Protocol) Doors won't unlock unless the disarm/unlock button on the remote starter is pressed the 2nd time. I have tried enabling/disabling EVO ALL options B1 (Driver Door Priority Unlock) and B3 (Double Unlock Pulses) with no avail. Is there something else we could try?

0

Could the INT-SL+ be reused in a different vehicle?

As the question title states, could this be transfered/reused to another vehicle? If so, is there a hard reset procedure needed?

0

Compatible Compustar RF Kits

If connecting or using a Firstech/Compustar RF Kits to the EVO-ONE or EVO-ALL, would you need other special parts? I am reading on the pdf guide # 19941 and it mentions a "RF converter"? is this something you provide with the bypass module, or I have to get this somewhere else?

Next is, do you have a list of compatible Firstech/Compustar RF Kits/Remotes with the EVO-ONE or EVO-ALL? 

 

Thanks,

0

2014 Dodge Grand Caravan - Not Programming

Could you please verify if the 2014 Grand Caravan will actually work with the EVO-ALL as stand alone remote starter? We have done two of the 2012 model last year and it worked great. We have tried installing it into a 2014 model this weekend and the EVO-ALL will not program at all (when we put the key on ign, the blue led will turn off - no flashing - and it'll turn back on when we pull the key out, thats it). Triple checked my wiring (i mean there were only about 5 - 6 wires needed to be hooked up into the ignition harness; made sure that the CAN Low and CAN High were right colors and were not reversed) and also tried two different EVO-ALL modules and harnesses The service # of the first EVO-ALL we have used is 001A06 349006 and I could give you the second one if needed Please assist and verify if it actually is compatible on the 2014 Dodge Grand Caravan. I have set up a time to go into the customer's workplace and try this again today. Thanks

1

2008 G37 Wont Start on 3x Lock on Standalone Configuration

I have tried 2 different EVO ALL modules and re checked all my (soldered) wiring. Vehicle won't remote start upon pressing 3x Lock but it will start when the external input (yellow/black wire) is momentarily grounded. Did I miss anything?

0

Output for horn (honk) from EVO ALL as standalone?

We've done a bunch of Toyota/Lexus using the EVO ALL as standalone remote starter and it works flawlessly (except the whole no key take-over part, which is inconvenient). My question is that... these vehicles have a separate siren/speaker (very low volumed beeps) for the lock/unlock confirmation. Is there a way for the EVO ALL could produce a momentary neg output that could be connected to the horn when the lock button is pressed in order to provide a louder audible confimation that the lock signal is being received by the vehicle? A customer just commented on how this feature will be very useful This is not an issue for the Chrysler or the Fords since their factory keyless entry lock signal is connected to the horn already.

0

Can the EVO-CHR be used as standalone remote starter instead of the EVO-ALL on compatible Chrysler vehicles?

If yes... could you please post the wiring diagrams for it including the with and without the use of the THAR 1 and 2 Thanks!

1

Could I have a detailed explanation/description on the EVO ALL programmable options from option 13 all the way down?

Also, if option 12 is on, do you have to have 19 on as well? How do they work together?

1

EVO ALL standalone starter on a PTS, which wire can be grounded on unlock to prevent shut down when door is opened?

I did this on a 2007 Infinity G35 in the past and got an answer from your phone tech support and it worked. I just forgot which wire it was on the EVO ALL and if it is compatible or can be applied to other vehicles with PTS and RFID... lets say a 2007 and a 2013 Lexus ES350 Thanks

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue